Ewikon released its HPS III-MH Series multitip nozzles for open and direct horizontal gating. The Mold-Masters Pivot-Link is a new rotating manifold for automotive lens applications. Mold equipment ...

Featured this week: A mold base with hot runner system that can be customized with just a few clicks on a configurator, next-gen visual-defect analysis technology, and more. During that time, he ...

The tool was built by F&S Tool Inc. (fs-tool.com). Coinjection is controlled by direct sensing of melt pressure and temperature in the hot runner. Mold-Masters says its IRIS nozzle is very compact—the ...

Running purging compound through hot runner channels can remove residual materials while leaving a minimal amount of residue behind. This ensures continued proper and efficient operation of a molding ...

Fraser, Mich. — PCS Co. is out with a new hot-runner temperature controller and oil filtration system. The TC50-brand controller comes in two models for six or 12 zones of control and features a ...

Westfall Technik’s MHS says its patented pneumatic actuator technology represents a paradigm shift from the standard design’s ...

From the time that a single raindrop hits the ground, it begins its travel to a larger body of water. An interactive tool called River Runner (samlearner.com) shows the path of streams, creeks, and ...

Cycle time is the primary cost measure of the molding process, and cooling represents about 80% of the molding cycle (see Figure 1). The thicker the part, the longer the cycle time. However, the ...